Connecting Sensor Cables to PhysioCom 2

The PhysioCom 2 device comes with a the PhysioCom 2 amplifier, 5 snap-in sensor cables.
The sensor cables are wrapped in 2 separate bundles. 

Channel 1 contains 3 cables: red for active, black for reference and green for the Ground sensor.
Channel 2 contains 2 cables: white for Channel 2 active, Brown for reference and a jumper cable for linking the black and brown reference cables together.
The PhysioCom 2 device ports are labeled +A- (red and black), +B- (red and black), GRD and (C).  The red "A+" port is the Active port for Channel 1 and the black "A-" port is the reference port for Channel 1.

The rec "B+" port is the Active port for Channel 2 and the black "B-" port is the reference port for Channel 2.  The "GRD" port is the shared Ground connection for Channel 1 and Channel 2 and the "(C)" port is unused by SmartMind.  A labeled diagram is found below showing the port names and locations.
For a 1 Channel placement, you will only need the Channel 1 batch of cables (red, black and green). 

  • The Red sensor connects to the red "A+" port.

  • The black sensor to the black "A-" port.
  •  
  • The green cable connects to the "GRD" port to function as the ground.
  •   
For a 2 Channel Placement, you will need all 5 cables and the jumper.
  • The Red sensor connects to the red "A+" port foor Channel 1.

  • The White sensor connects to the red "B+" port for Channel 2.
  •  
  • The green cable still connects to the "GRD" port to function as the ground.
  •  
  • You will use the jumper to connect the black "A-" port and the black "B-" port together.
  •  
  • Then plug the black cable into the jumper located at "A-" port and the brown cable into the jumper located at the "B-" port.

 

 

 

 

 

BrainTain Support has written 17 articles